|
Then i put the paper on the pin that the sear rests on (like Hsuve does in his "Trigger job with pic" thread.) The peice of paper i used was just a 8 1/2 inch notepad paper. I just cut a slit about 1cm off the edge of the paper. (So it was 8 1/2 inch's long and 1cm wide) Then i just rapped it tight and put a small peice of tape around it. (look at Hsuves pics for this step, his are better)
i dont think you really need a visual aid, but here is a crappy one anyways
The red arrow is the paper on the pin the sear rests on and the blue one is pointing to the sear
__________________
Wow...this is one classic thread.....ah, the good ol' days of OT...
 METAL MAFIA
HOOLIGAN
LP Spyder TL+
CP Flame drop
CP ASA on/off
CP Spyder adapter
Evil Pipe barrel system
BRMC Anti-chop delrin bolt
KAPP twisted cocking rod
Check-it Products 15° VA
32° spring kit
Air America Vigilante with LP spring
12v smoke revvie w/ Vortex impeller, Pbr stickers, and TurboRev board
32° Magna Port valve w/ Lapco cupseal
48/3000 Pure Energy n2 tank with Extreme Rage cover
Custom Trigger Job and lots of other home done mods
Dye mini guage
Dye sticky grips
Dye (blue) 2k3 Pants
Dye (blue) 2k2 Jersey
Dye (blue) Invision
Dye (black) Sockhat
Last edited by mikek2111987 : 05-29-2002 at 01:53 PM.
|