Thread: Picture Thread
View Single Post
Old 11-14-2002, 11:51 AM   #55
jawpaul
Bushmaster Brotherhood
 
jawpaul's Avatar
 
Join Date: Jan 2002
Location: North East, TN
Send a message via ICQ to jawpaul Send a message via AIM to jawpaul Send a message via Yahoo to jawpaul
Here is my current setup.
Specs:
Brass Eagle Raptor Model 1444 Blue
Vertical Adapter
12" Eagle Works Aftermarket barrel (painted black)
32 Degrees Gel Grips Clear
Custom Trigger Job
Custom Stainlees Steel Connecting Pin
VL200 Hopper

It is a bit rough around the eedgees but performs well and is reliable since I made a stainless connectign pin. About the trigger job all that I did was cut a small peice of stainless rod and mount it as a backstop behind the trigger. You can see it in the picture near the safety. I also filed and sanded down the trigger so it is now very smooth and wide, no more dreaded steps on the trigger. I have also added a thumb rear velocity adjuster from a Pirahna much better and cheaper than the 32 degrees rear velocity adjuster.
I am planning on milling off the top half of the gun and doing some other things to make it work. Total investment so far including tank & goggles less than $60.
Attached Images To view attachments your post count must be 0 or greater. Your post count is 0 momentarily.
__________________
Silver Bushmaster B2k Gen 4
Dye Boomstick 10"
Black Dye Sticky Grips
Black Evolution 2 y-board inside
Crossfire 47/3K HP
Black CP Rail Mount
Centerflag Doolie LP
Dye Attack Pack Plus 4+3

Last edited by jawpaul : 11-14-2002 at 11:54 AM.
jawpaul is offline   Reply With Quote