Location: Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and
dude that look sweet, (i would of gone cobalt blue, but nice )
Location: Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and
SK, is this a picture of yours? where did you send yours?
if it was that bad how come you didnt send me an e-mail about it. if you remember i had told you how i could tell one was alot older gun by the marks all over the body, the quality of aluminum used (not so good alloy, wasnt exactly 6061, had zinc content) and the fact it looked like it had been tried to have the old ano sanded off. mostly the reason the newer one has a nicer finish. its body was perfect except the dinks in it where it had been hit by the other body, sitting against it with nothing to protect between them in shipping. i tried to polish it up, which i had told you this and explained it all in messaging before. and showed you the pic and i thought all was understood. i had told you that the older body woulndt be as glossy unless i spent ALOT of time resmoothing and polishing of the body.
it helps to know from the people what is wrong so it can be fixed, instead of hearing about it somewhere else, if your not happy TELL ME, dont just post where i rarely look.
and they are the ones in the pic paint bull attached.
his is the bottom one, as was showed him before i sent them back.
__________________ www.fearfactorypb.com
custom guns and repair, mods of all kinds. MACDEV dealer
Fear mods, tribal, imp, angel, what have you
custom anodizing
if you look very close those are tiny pits in the aluminum, trapped pockets of air when the body was extruded. they are actually in another matrix i have here that is very old. its still has factory ano. only reason you didnt notice them before was it was black. find someone with another early one and look at the body closely, it will have the same small pits. only way to get rid of them is to sand the area down smooth, which would take alot of time, and take off quite a bit of material to smooth. there more noticable with the grayish color because more dye was trapped in those pits.
i also figured out why they ended up a blueish color :O, one of the guys helping me out was mixing a custom color for me, and ended up pouring a cup of blue into my gray dye, then he didnt tell me because he didnt think it would matter. needless to say no one else gets near the dye anymore.
__________________ www.fearfactorypb.com
custom guns and repair, mods of all kinds. MACDEV dealer
Fear mods, tribal, imp, angel, what have you
custom anodizing
Location: Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and there Here and
i think they look sweet, I like the bottom one just as much if not more.... but i geuss i dont have a close up
)
Hybrid Mode
