Proto Matrix Rail- Questions Answered!

[<IONFREAK>]

Since the valve is an unbalenced spool valve similar to the ion, is the valve a 2-way like the ion?

[protofreak]

Originally Posted by Terminate

yah the 250fps would make a diff since i run at 290 +/- 4 i got about 600-700 on the same fill with a dwell of i think 19 atm...

mines at 298 +/- 2

[protofreak]

Originally Posted by <IONFREAK>

Since the valve is an unbalenced spool valve similar to the ion, is the valve a 2-way like the ion?

well if the boost foward technolgy is taken in to it would be a 2 1/2 or a 3 way

[Terminate]

but the diff Freak is tha i juse ruan a .692 back and don't bother matching paint so that does effect it slightly.... when i used my friends barrel kit and matched paint one day i was doing 297+/-2 but he difference in actually playing ability has yet to justify me buying a kit since i really love my ultralight barrel... althought i might buy the .688 back for it too and just see how that shoots... either way 290 +/- 4 is fine with me 95% of the time since i don't consistanly play competative atm i just practice with local teams

[StumpyManager]

um, sorry to bother people again, but i was changing the battery on my Rail, and all of a sudden, the whole wire thing just snaps right off. What can i do to stick it back on?

[protofreak]

call dye and get a free new one

[Basfire5]

yeah just call em they will send u a reinforced new one free but it will take a week or so

[darktrooper5]

Those harnesses are breaking pretty frequently. I know for a fact that any
DM4/5/C and PM5/6/7 harness will fir in there. Some may have longer wires, but in some cases, thats better. Just be careful guys.

[protofreak]

treat it like a woman nice slow and gentle

[Trasker]

How do you connect the eyes and is it really a gas hog?

[protofreak]

they clip/slide into the slot like the battery connector does and once youbreak the hyper2 in it realy inst that bad of a gas hog

[TheArsonist21]

maybe we should all call dye and get another bettery harness so if in case they DO break, which it sounds like they will, we have a spare..

I dont know, seems like a semi-good idea to me? I dont want my gun down for a week due to a design flaw on Dye's part.

[protofreak]

if it hasny broke yet it probly wont some of the old rails were sent out with a thicker wire harness

[thehittman42]

when i call dye do i have to give them my gun scerial code?

[protofreak]

if you filled out the warrenty card they have it already

[Basfire5]

I just got a new ASA for my pmr, a ndz with a bob long gauge. When i attached it, it seemed to be on tight but gas still leaked a bit out of the barrel. When i tried to shoot (eyes off, no paint) the noid seemed to click and release a small amount of gas, but nothing else happened. Can anyone help me out with this?

[protofreak]

lube your o rings and it sounds like you pressure is to low coming out of your reg

[Basfire5]

how would i fix it?

[protofreak]

either your tank is below 450 psi output or just raise the pressure coming out of the hyper2 but raise it slowy

but if raising the pressure make the leak worse its not the hyper2 output it would be a o-ring or its way to high

[XSVfan1324]

Yeah that should fix it. with dye guns its always just an o ring or something, usualy.