Help with new sp-1

Fang11 · 04-24-2009, 02:53 PM

i bought an sp-1 during the winter and brought it out to shoot, but when i attached the co2 tank it didnt do anything besides make a little sucking noise. the tank is full and the battery is new. when i tried shooting it just made the same noise as if the tank wasnt even attached, that little beap noise. can someone please help me?

moe371 · 05-03-2009, 05:49 AM

Had the same problem before. Back the tank off a 1/4 of a turn and see if that helps. I think the pin on the SP-1 has a problem with some tanks.
moe

di$TOrTed · 05-03-2009, 08:05 AM

Lower the pressure all the way and turn it up slowly until you are at the correct velocity. The pressure could be too high and causing leaks or too low to fire. It's hard to tell without a gauge on these markers.

Also, put in a new battery before you try this.