Eblade settings

blizz · 09-24-2005, 03:09 PM

Before you say "Use FF w/ eye on!!" I already know that. I found these settings...

con-22
coff-15
cdel-4
tpul-2
trel-2

I have them in my gun right now, and they rip, but I have to air to test with paint. Will they even work, or will it cycle before a ball can drop?

Also, does turning the eye on keep these settings?

Thank you.

Dark Master · 09-24-2005, 03:12 PM

We don't know what parts are on your gun....

Just put it on Factory fast and lower the Coff a bit.

blizz · 09-25-2005, 05:34 AM

I am shooting a..

'03 autococker
Eblade
STO ram
Stock bolt (Hopefully I can get a new one with my next paycheck.)

I think that is everything that would affect how fast the gun cycles.

ShorTi · 09-25-2005, 05:52 AM

Everything has a effect on how the gun cycles. A black block takes off mass, bolt - mass, cocking rod - mass, there's alot of parts that can make a small difference. As far as those settings go, im going to leave that for Dark or Uziel.

vantrepes · 09-26-2005, 12:52 PM

If that is an accurate list of the parts on your gun, with anything not mentioned being stock, then those settings will not work. I doubt you will be able to cock the gun at 22ms, let alone get a ball to load while doing it.
Also, 15ms is going to give you wonderful shoot down.
Try this: http://www.moodypaintball.com/pages/tech/eblade.htm It's a step by step guide to timing an E-Blade for the parts you have.