Step 1: Remove the bolt and ram.
Step 2: Lube up the ram gauge just like how you lube your ram normally, except there's no piston or hammer on the ram gauge. ( DO NOT LUBE WITH OIL!!!!!~GREASE ONLY!!)
Step 3: Install the ram gauge onto where the ram is. Installing the ram gauge takes a little more effort to install more than the ram itself. You don't need to install the bolt.
Step 4: Air up the marker. If there's a leak, de-gas the marker and remove the ram gauge. Check for any damaged o-rings, and if there are any that are damaged then replace and then re-lube the o-rings and the ram gauge. (the o-ring is the same size as the tank o-rings)
Step 5: Adjust your LPR to desired psi (should be under 100 psi). Take 2 clearing shots to clear the old adjustment each time.
Step 6: When you are finished with adjusting the LPR, de-gas the marker and remove the ram gauge. Re-install the ram and bolt.
by RaGeD P1NGA
Linear Mode
