macro lines

skatemasta460 · 03-03-2003, 06:14 PM

could anyone tell me how to install a macro line hose? My hose blew out and i need to replace it. anyone have steps or a website that i could use to repair it??

ZAust · 03-03-2003, 08:15 PM

just get some new hose, and push it into the fittings. you can get hose on pbgear.

cocker kid 2k2 · 03-04-2003, 11:07 AM

On the fittings, if you try to pull out the hose these rings will come out, push those down and then pull the hose out at the same time, this will allow you to release the hose from the fittings. Then to install a new hose, push the ends od the hoses into the fittings like they were before.

skatemasta460 · 03-04-2003, 04:58 PM

um...there is no rings......

cocker kid 2k2 · 03-04-2003, 05:03 PM

When i say ring i mean the part of the fitting that comes out when you pull on the hose itself.

skatemasta460 · 03-04-2003, 05:39 PM

hmm.....the hose just doesnt want to budge when i press down on the ring....

BourneKiller · 03-04-2003, 06:32 PM

Welcome to our newest sticky