perfect way to set up the 98 flatline with the shroud without testing it(this is for a aligned barrel, a velocity of 270 will be needed)
1) take the adapter in your hand and put the barrel. line the notch on the top of the barrel so there is equal space on each side of the hole on top of the adapter
2)tighten the adapter pinch bolt
3)use marker paint and mark the notch on the bottom of the adapter and the barrel
4)let it dry
5)remove barrel from adapter
6)put adapter in barrel
7)put the flatline shroud on
8)now put on the barrel and line up the paint exactly(should be easy since paint runs along the inside leaving a exact imprint)
9)tighten pinch bolt and line the center of the adapter notch in the bottom with that of the crack where the recievers meet
10)tighten reciever bolts
11)now the paint will stay there and you'll now where it goes perfectly when you take it of to clean gun..ect..
perfect way to line up flatline from the start
Linear Mode
