Originally posted by The Kampfer Nice work as always, Viper. A+ :up:
About Armotech....Hehe, not my thing.
I perfer MP-5 over M16/M4 anyday anytime.
Here is my new gun, coming soon.
Dude u dont know much about Armotech then do you?
The WG-75 (Mp5 version) was out for a while then discontinued due to a trigger problem.
It is being released again probably in April, way better than before. Looks ALOT like the Mp5, and you can fit TONS of airsoft or real mods on it with a bit of modifications to it, it looks insane too.
__________________ Hoot: "Nice man, very smooth." Gordon: "Single shot to the engine block."
-Black Hawk Down
Vm-68 bought for 30 bucks , its 10 years old and was used as a rental gun... considering these facts the gun remains considerably accurate at 20 - 25 mts. (the magic of cleaning and oiling) , the pieces were milled out of aluminium , the fake gas piston is actually an expansion chamber , the barrel is armson , the stock was a gift , so was the ammunition box attached to the lower side of the gun...
It is however not yet completed... only about 65% some other pieces have not yet been mounted... a new PKM style stock will be built for it later.
This gun is supposed to function in a role of Squad Automatic Weapon.
Im not single im dating my hand, but i might dump her for her friend lefty b/c im not getting enough romance - Winchester
Here's an old side-cocking Kingman Spyder Classic with an actual H&K 91/G3 Thumbhole stock, 16" CMI Tru-Flight Barrel, 32 Degrees Vertical ASA, Simmons 3x9x50 Rifle Scope, and 47mm Walther Red Dot. This thing is fun to play with and really intimidates newbies in the woods.
Mainly done just for fun. Making an actual assault rifle stock fit a paintball marker wasn't that difficult. This thing really irritates speedballers, which is part of the fun.
Here is my work in progress, its an old Mokal company Mirage semi-auto, I disgraded the bottom asa and attached a 12grm adapter using a duck bill which i fit onto the trigger frame (it came little crooked), connected the co2 suppy to the marker with a micro (yes micro no macro) line. Barrel is Taso 12 in from I&I (i hate that store) ported but needs a lot of work since its scratched to hell on the inside (bad finish job). I will be building a wooden grip over the adapter and the barrel to cover it and have good hold on the marker.
Inside the valve and the hammer have lighter springs since i played with a ION reg on this marker (and it did shoot at 200 psi).
I'm slowly stripping the black iodizing (which they applied very well) and will polish the whole marker to a mirror finish.
__________________ Red Piranha BLVF, E-Force trigger frame, Evil Driver Barrel, HT :R-Drive Regulator, Pure Energy 3000/48 tank, ACI drop forward, Extreme Rage Overdrive hopper with electronic eye beam mod