Originally posted by taso_winforce
well i was turning my pressure up on my palmer stabalizer and i guess i turned it up as far as it would go and i heard a snap and when i tried to turn the pressure down the bottom came unscrewed. is this okay or did i screw up the reg?
It should be ok so long as you didn't strip any threads in the cap.
De-gas the gun!
and fire it few times to make sure its empty
Unscrew the cap
Take the screw out of the cap and check the threads.
Re-install the cap. A nickel will fit perfectly into the slot. Use pliers and get it real tight. You may bend the nickel.
We get hundreds of emails at Palmers and it may take us few days to get to them all. A faster reply is only a phone call away. An instant reply can also be had via thePOG forum
Most of the regulars there are very knowledgeable about PPS gear.