Trilogy Facts - Page 19

Loncove · 08-31-2005, 07:59 PM

do you think my trilogy can shoot as smooth as this?

Click here to watch Mech-hostinger

Dark Master · 08-31-2005, 08:13 PM

Someone's short-stroking.

Loncove · 08-31-2005, 08:15 PM

aww i knew it. but it did seem pretty smooth....

detroitpb · 09-01-2005, 06:26 PM

eh if i remove the hoses do i just pull em off?and do i do the smae for putting back on?

Dark Master · 09-01-2005, 06:42 PM

Chances are the hoses are on pretty good. That is, if you haven't take them off before. You could try pulling on them, or try some needle nose pliers.

For putting them back on, just push them on.

detroitpb · 09-01-2005, 07:58 PM

k thx

detroitpb · 09-01-2005, 08:03 PM

the pliers i got have ridges
and i dont wanna cut the hose

Dark Master · 09-01-2005, 08:04 PM

Well, if you grab for the bottom of the hose, chances are if they tear a bit, they won't leak. Plus, there probably is a little extra slack in the hose.

detroitpb · 09-01-2005, 08:10 PM

there on there pretty good

Dark Master · 09-01-2005, 08:11 PM

Then heat them up with a hair dryer. It'll make them expand more.

detroitpb · 09-01-2005, 08:18 PM

ill do it tommorow cuz i tore one bit and its gettin late

Loncove · 09-01-2005, 08:33 PM

i but a lil gun oil around the barb and it when in nicely. and if you are using pliers with ridges, but a pice of cloth around the hose put the pliers around the cloth and push it in with the cloth sourounding it so you wont shred the hose... you get what im saying??

detroitpb · 09-01-2005, 09:13 PM

yea
ill do it all tomorrow, and i wont have a job for a while so im gonna try and put some new stuff on asap

Dark Master · 09-01-2005, 09:14 PM

detroitpb · 09-02-2005, 05:40 PM

eh if tear is it ok as long as it below the top of the valve things?

Loncove · 09-02-2005, 05:52 PM

if it is torn in any way, you should do it over again cause its going to get worst eventually and then you will have to do it again anyways. so i would just cut the tip that was torn and then connect. put some gun oil in around the barb, not to much. it wil slide on easier.

detroitpb · 09-03-2005, 01:55 PM

yea i gased it up to see and the one from the ram was leeking, and i think at the actuator rod too

20 pages possibly

detroitpb · 09-03-2005, 02:09 PM

er the thing on the right side of the frame under the 3way

20

detroitpb · 09-03-2005, 05:49 PM

for loncove

Dark Master · 09-03-2005, 05:50 PM

Linky no worky.