* Low Pressure operation
* Threaded low-rise vertical feed tube
* Quick Pull pin for easy field-stripping
* On/Off Indicating LED
* Adjustable Balls Per Second
* 4-Way Adjustable Trigger
* Battery and board in grip for easy access
* Wrap-around Rubber grip panels
* Accepts standard 45 grip panels
* 12" ported barrel with Timmy threads
* Paintball Detection System
* Easy Cleaning ball detent
* Delrin Bolt
* Accepts standard duckbills and drop forwards
* Extremely low profile
*The ProMaster is available in gloss black, silver, blue, and red.
Q: how do you operate the promaster board?
A: The ProMaster stock board is capable of 4 (four) different firing modes, each either capped at 15 BPS or uncapped.
To change firing modes, dwell, or ROF cap, you must first remove the right side clamshell grip to access the DIP switches on the board. The switches are numbered on the front side of the switch block for easy identification.
Quick reference to DIP switches:
1. Rate of Fire (ROF)
Switch #1 is on the bottom of the board closest to the wiring harness connector, while switch #4 is on the top furthest, from the wiring harness connector. For a switch to be in the ON position the switch finger must be pushed towards the front (barrel) of the marker.
Switch #1 is used only for the ROF limits. With switch #1 in the OFF position ROF is limited to the loading speed of your hopper or unlimited. With switch #1 in the ON position your marker ROF will be capped at 15 BPS.
Q: Does the promaster come with an Asa and/or macroline?
A: no it doesn’t, you need to buy an Asa and a macroline kit
Q: How does the Promaster operate?
A: it uses a air– ram poppet design, much like a Angel, timmy, ego and cyborg
Q: Does the promaster come with a Adj or clamping feedneck, and what threads does the feed neck have?
A: No it doesn’t come with a adj feedneck. The feedneck threads are ICD/bushmaster, even though you can use Impulse/shocker feed necks its not recommended b/c you can damage your body threads. Some great feed necks can be bought here: http://www.chipleymachine.com/mm5/me...tegory_Code=FP
note: some feednecks are being advertised as Impule/Ion/ICD threads, in other words they are advertised as fitting all three. These feednecks are actually Impulse/Ion threaded, not ICD threaded, and should be avoided as such.
Q: Can the promaster use a bushmaster valve and LPR
A: yes, they are interchangeable
Feel free to add more
i made this b/c lotus was too lazy