Piranha EXT PRO Fade Limited Edition G3
14" Teardrop barrel
PD Omen Chip & Sight System (Eye)
PD High Flow Valve Pin
20 BBS Piranha
Greater Air Flow
The Pin does exactly what it is supposed to. It decreases operating pressure. It lowers the operating pressure about 50 - 100 psi which means; Saves gas less likely to break balls, can operate faster and its quieter.
The difference between the stock flow pin and the high flow pin is that the near cup seal the pin is machined down to allow more air flow. Get this pin because its a cheap and easy way to make your marker perform to its fullest.
Makes your Piranha have a even lower operating pressure and this is good, real good.
10 out of 10
Last edited on Sunday, April 11th, 2004 at 6:54 am PST
2003 piranha eforce PF, boss bolt, bossblade adjustable trigger, evil valve, bob long torpedo reg, pmi drop forward dye 14" xcel barrel, pmi pure energy 88ci 4500 tank.
Better in every way compared to stock
None for the price.
I bought this pin with my turbo valve to lower the pressure in my eforce marker. it worked great while i used it but i eventually upgraded further to an evil valve kit. for the price is it worth buying the hi-flow pin but i would also invest in a new valve to. still its a great upgrade and your only going to spend around 30 bucks total. it lowers operating pressure quite a bit with a reg.
Definetely worth it if you are thinking of upgrading your piranha
Does what it's supposed to, achieves higher flow rate. Quality workmanship, cheap effective upgrade.
Not a whole lot to it but it was machined nice, no burs etc. Can't really quantify how much of an improvement if gives your flow-rate but it seems to work fine, a cheap upgrade that can only help. A good addition to a high flow valve that doesn't come with it's own pin like the Turbo Valve, but can also be used with a stock valve. A must for someone striving towards a low pressure setup.
I recomend this product you can't go wrong, cost effective upgrade. Especially if your lookin at upgrading your valve to a Turbo valve.
Piranha E-Force VTL
PE Inline Reg Chrome (Expansion Chamber Backup if needed)
Turbo Valve with PD High Flow Pin
Progressive Barrel(upgrading to The Pipe)
Evil Delrin Bolt
Chrome WGP Flame Drop Forward
47ci3000psi steel backup
New Board For Frame(20+bps)
Anti Chop Eye
12V Revy with jmj Vortex and X-Board(Soon to be Egg2)
does what its supposed to do.
none so far. at least not that i know of.
Works great for low pressure....
for some reason when i wasnt using low pressure my gun wouldnt shoot above 250 fps...i have no clue why, but now it does, and also i dont have a ram air chamber. i thought that would be a problem but its not, im sure if i didnt have that pin it would be a problem. plus its cheap too, why not make ur gun have a higher air flow for like 10 bucks....not sure of actual price check out their site. but for now, nothing bad with it, if it changes ill let everyone know.
if u have the turbo valve, ur obviously looking at or are using low pressure so get this pin, u wont be disapointed.