E2 eblade Flashed (delron trigger)
Ans Gen X2 inline reg
Drop w/ check it on off
Evil pipe kit
Works just like all others.
This bolt is just like all other delron bolts. They all weigh very little and all reduce wear on the gun by a large amount. I have tried to see if I can jam this bolt like the other guy says. I brought the gun up to fifteen BPS and kept it there for a whole hopper. No jam. I tried this a few times with the same result.
I am not saying all delron bolts are the same, but they all work of the same basic principles. They reduce wear on the gun and weigh less. End of story. This bolt does just that. It works just the same as a supafly bolt. The only difference is when the marker is fired without a hopper on it makes a different tone.
Hey if this bolt is in your price range and you like it, then buy it. Most delron bolts are the same.
Im not sure what your talking about when you say the bolt jams?? You must of tested one that was flawed or something, cause ive shot tons of paint through my gun using there bolt and it works fine, even if i short stroke it, it just pinches and doesnt break any paint...
For the price, this is a good bolt, its the stock bolt for the CCM markers but works great i think... no need for me to upgrade it
Delrin back block
Centerflag 68/3000psi nitro
This is a very heavy very slow bolt and it jams alot compared to full delrin bolts, another thing bad about it is the price. it is way to expensive for its price and should only be used on slow mech cockers that you dont care about. If you have an eclipse or Race than dont buy this bolt cause it will slow you down
If you have a mech cocker you might consider buying this one over your stock bolt but otherwise its a waist of money
3 out of 10
Last edited on Tuesday, October 26th, 2004 at 6:33 pm PST