Made from the finest quality T-6061 Al, these feednecks are made to last, and as always, are covered by the CCM lifetime guarantee. Secure that hopper with this neck, it tightens around the entire hopper to ensure a snug fit, while not damaging the hopper.
The Chipley Custom Machine Feedneck is older, so while it may be available used and in a few cases new, it is not commonly available anymore.
Easy to clamp hoppers and can be used with any hopper.
Not as low as the ND no rise.
Great product, holds hopper on tightly and sercurly. Can fit any hopper which is a plus and is easy to tighten clamping ring. Not as low as the ND no rise but this is only by a few millimeters. I could easy hold my gun by my hopper and shake it and the hopper would not move at all!
If you need a feedneck for your imp this is the one to get.
dead on products drop
ndz magno trigger
ccm clamping no rise
it is good to fit ne hopper
it gets worn in too quick, hopper becomes loose when feedneck is fully tightened
it is a good product to fit ne hopper u want bcuz it is adjustable also it is low profile to keep you in the game longer awesome product it is also good to give your loved hoppper a better look w/o shaving it down to make it look ugly
good product a must for a front or mid and good for hyper ball airball doesnt matter as much but good product
-Provide a very snug fit for any hopper
-Available in different heights
-Allen wrench reliance
I bought my low rise CCM at Ultimate Madness in April, and have not been disappointed. It fits every one of my hoppers (from tiny-necked Halo TSA to the fat-neck Halo B) and holds on tight. The only complaint I have is that of the soft annodizing. Mine is black, but now has a couple silver stripes due to fingernail and allen wrench scratches.
Great buy, I give it a 9 because of the anno problem.
Smart Parts Impulse
CCM Low-Rise Feed
Shocktech Superfly Bolt
Smart Parts Progressive (Soon to be Custom Products 2-piece)
Smart Parts Sticky Grips
Stock Max-Flo Reg
Crossfire 68ci 4500psi Tank
Clamping screw instead of sleeve insert, available in three sizes
In my personal opinon, if something needs doing and nobody's stepping up to the plate, then Chiply will do it. The CCM feed neck is the single best vertical feed neck available for any marker. I've seen people use other adjustable feed necks, and my own Twister Feed's sleeve was fractured from a hit to the feed neck, and this one is nearly impossible to break short of putting it in a vice. Really, unless you lose the screw somehow, this thing refuses to break, and also refuses to break feed necks.
Tired of your stock high-rise feed neck or your Twister broke? Get this, it will remedy all of your problems. Actually, just get it, no matter what. It's available in three sizes (no-rise, low-rise, and high-rise) and a bunch of colors, so why not?
screws into the body, clamps tight and stays tight, has a low profile.
cost, you need an allan key to tighten and loosen it.
First of all the low profile moves the hopper down qiute abit, probably about 2 inces. It screws into the body and remains tight with a bit of lock tight. the clamp is with a band that is threaded with a screw, using an allan key you can tighten it so the loader will not move at all, I have not had my loader loosen up through out the day either. the only thing I don;t like is that the band can be lost if you loosen too much to where it will come out of the groove.
excellent feedneck, secures tightly, looks good but is expensive, if your serious then its worth getting.